Like always there are few things that you are going to need to help create this look:
- A pintail comb
- Hair grips
- Hair pins
- Hair clips
- A normal brush
- Crimpers
- A 'rat'.
So to start off this incredibly funky design, you have to crimp the whole head of hair. We're still working on the Katie heads so we had to be careful how much heat we used just incase it damaged the hair. To make sure that I got all the hair I sectioned off pieces of hair and did it that way. Crimping the hair took a lot longer than I thought it would so if I was going to use it in my final design I'd have to take that factor into consideration. Then using the brush, we had to brush out the crimp so that it made the hair look like a mini afro. Once all brushed out we had to section a piece from the top of the head to behind the ear and back comb it so that it created an almost crescent shape over half the head. This part was incredibly difficult and I struggled with trying to get the correct shape.

The next step was to create that fabulous heart shape, and to do that all I had to do was roll the hair away from the face and grip it where the roll met the head. Then using the hair pins just tease any pieces of hair that don't look quite right and pin it where you want it to go. I would show you the picture but I'll save it till the end so you can see the two different ways next to each other.
So to create the heart shape with the 'rat' it is slightly more complicated. You will need to section a piece of hair close to the top of the head and create a small French plait towards the ear. Although you don't have to take it all the way down to the bottom of the head, you will have to plait it so that it stops in the middle of the head. It's rather hard to explain. Anyway the next step is to fold over the rest of the plait and grip it so that there is a thick plait like thing. Like I said it's hard to explain. You then get the 'rat' and grip it to the plait so that it can hold itself up. You then roll the hair over the 'rat' and grip it so that it covers it and none of the 'rat' can be seen. Then using the hair pins, pin any flyaway pieces of hair down and then your done!


So after having a go at both of the different ways, I found that I enjoyed just back combing the hair and rolling it rather than using the 'rat'. I also preferred the outcome of just the back combing as it created a more sloping curve and I was able to get more of a rounded edge, while the 'rat' made quite a high curve and I couldn't quite get the shape that I wanted
, while that was the aim I just didn't find it as aesthetically pleasing.


No comments:
Post a Comment